Omron E5EK-T - Page 12

E5CK-T
E5CK-T
12
Output Unit Ratings and Characteristics
Model Control output 1/Control output 2
E53-R4R4 Relay / Relay
E53-Q4R4 V oltage (NPN) / Relay
E53-Q4HR4 V oltage (PNP) / Relay
E53-C4R4 4 to 20 mA / Relay
E53-C4DR4 0 to 20 mA / Relay
E53-V44R4 0 to 10 mA / Relay
E53-Q4Q4 V oltage (NPN) / V oltage (NPN)
E53-Q4HQ4H V oltage (PNP) / Voltage (PNP)
Output Type Specifications
Relay
Voltage (NPN)
Voltage (PNP)
250 V AC. 3 A
12 VDC, 20 mA (with short-circuit protection)
12 VDC, 20 mA (with short-circuit protection)
0 to 10 V
4 to 20 mA
0 to 10 VDC, Permissible load impedance:
1 kΩ min., Resolution: Approx. 2600
4 to 20 mA, Permissible load impedance:
500 Ω max., Resolution: Approx. 2600
Option Unit Ratings and Characteristics
Model Specifications
E53-CKB Event input Contact input:
ON: 1 kΩ max., OFF: 100 k Ω min.
No-contact input:
ON: residual voltage 1.5 V max., OFF: leakage current 0.1 mA max.
E53-CK01
Communications
RS-232C
T ransmission method: Half-duplex
Synchronization method: Start-sto
p
synchronization (asynchronous method)
E53-CK03 RS-485
S
ynchronization method:
S
tart-stop synchronization
(
asynchronous method
)
Baud rate: 1.2/2.4/4.8/9.6/19.2 kbps
E53-CKF T ransfer output 4 to 20 mA DC:
Permissible load impedance: 600 Ω max.
Resolution: approx. 2,600
Note: Event input is used for switching the target value, run or stop command, or automatic and manual mode with an external signal input.
Nomenclature
Operation Indicators
RUN/RST Key
Up Key/Down Key
Display Key
Display 1
Display 2