Omron fh series - Page 41

37
Like shown on the right figure,
if an error message is displayed
on the ACE’s monitor window,
the connection has failed.
Check the wiring and others.
4
(Operation of the Vision Sensor
and ACE)
Like shown on the right figure,
when [Get] is clicked on the
Main Window of the Vision
Sensor and the current position
of the robot on ACE's monitor
window is displayed at the
same position on the Main
Window of the Vision Sensor,
sending/receiving commands
between them have been
succeeded.
* Correspondence relation of
notation
Vision Sensor
ACE
W
yaw
P
pitch
R
roll
Additional Information
This document does not provide operation, installation, and wiring methods for each
device.
For details, refer to manuals noted in Chapter 8 Reference Information.