Omron H3DS Series - Wiring Procedure for Screwless Terminals; Exposed Conductor Length; Wiring Connection Holes

H3DS-jLC
H3DS-jLC
33
Installation of Screwless Spring Terminal Models
Tools
A flat-blade screwdriver should be used to mount the cables.
Applicable Screwdriver
F Flat-blade, Parallel-tip, 2.5 mm diameter
F Flat-blade, Parallel-tip
F Flat-blade, Flared-tip
2.5 dia.
Cannot be used.
Examples: FACOM AEF .2.5 × 75E
VESSEL No. 9900-(-)2.5 × 75
WAGO 210-119
WIHA 260/2.5 × 40
Applicable Wires
Applicable Wire Sizes
0.2 to 1.5 mm
2
, A WG24 to A WG16
Applicable Wire Type
Solid wires, stranded wires, flexible wires, or wires with ferules can
be used.
(See note 1) < 1.8 x Diameter D (mm) x 3.0 (see note 2)
Conductor diameter d (mm) or length of sides a and b (mm) x 1.6
Wires with Ferules
Note: 1. If the overall diameter of the wire is less than 1.8 mm, do
not insert the wire past the conductor. Refer to the fol-
lowing
diagrams.
OK NG
2. If the overall diameter of the wire is over 2.8 mm, it will be
difficult to use double wiring.