Omron H5CC - Page 21

2121
H5CC
Timer
Mode b: Flicker I (Timer resets when power comes ON.)
Basic operation Detailed operation
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The status of the control output is
reversed when time
is up (OFF at start).
While the start signal is ON, the timer starts when the
power comes ON or when t
he reset input goes OFF.
Note: Normal
o
utput operation will not be possible if
the set time is too short.
Set the value to at least 100 ms
(contact output type).
Sustained Output
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The control output is turned ON when time is up.
While the start signal is ON, the timer starts when the
power
comes ON or when t
he reset input goes OFF.
Note: Normal o
utput operation will not be possible if
the set time is too short.
Set the value to at least 100 ms
(contact output type).
One-shot Output
Mode b-1: Flicker II (Timer does not reset when power comes ON.)
Basic operation Detailed operation
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The status of the control output is
reversed when time
is up (OFF at start).
While the start signal is ON, the timer starts when the
power
comes ON or when t
he reset input goes OFF.
Note: Normal o
utput operation will not be possible if
the set time is too short.
Set the value to at least 100 ms
(contact output type).
Sustained Output
* Start signal input is disabled during timing.
Timing starts when the start signal goes ON.
The control output is turned ON when time is up.
While the start signal is ON, the timer starts when the
power comes ON or when t
he reset input goes OFF.
Note: Normal
o
utput operation will not be possible if
the set time is too short.
Set the value to at least 100 ms
(contact output type).
One-shot Output
Power
Output
*
Start signal
input
Timing Timing Timing Timing
0
0
Power
Start signal
Gate
Reset
Control output
Set value
Set value
UP
DOWN
Timing diagram
Power
Output
*
Start signal
input
Timing Timing Timing Timing
tt
0
0
Power
Start signal
Gate
Reset
Control output
Set value
Set value
UP
DOWN
Timing diagram
Power
Output
*
Start signal
input
Timing Timing Timing
Timing
Sustained
Timing
0
0
Power
Start signal
Gate
Reset
Control output
Set value
Set value
UP
DOWN
Timing diagram
Power
Output
*
Start signal
input
Timing Timing Timing
Timing
Sustained
Timing
tt t tt
0
0
Power
Start signal
Gate
Reset
Control output
Set value
Set value
UP
DOWN
Timing diagram