Omron H5CC - Page 33

H5CC
3333
Timer/Twin Timer Selection Mode (Function Selection)
Select whether the H5CC is used as a timer or a twin timer in timer/twin timer selection mode.
*1. When the mode is changed to timer/twin
timer selection mode, the present value is reset and output turns OFF.
*2. Setting changes made in timer/twin timer selection mode ar
e enabled when the mode is changed to run mode.
If the configuration is changed, the set values and set time are initialized.
To initialize the set values and set time, set tim (timer) → twn (twin
timer) or twn (twin timer) →tim (timer) in timer/twin timer selection mode, return to run mode, set twn (twin time) → tim (timer) or tim (timer)
→ twn (twin timer) in timer/twin timer selection mode again, and return to run mode.
However, the output ON count monitor value (on-c, on1c, or on2c) a
nd cumulative run time monitor
(ot-c) are not initialized.
tim
twn
Power ON
Run mode
Timer/Twin Timer
Selection Mode
Timer/Twin
timer selection
* 2
* 1
Select either timer operation or twin timer
operation using the UP1 Key (DW1 Key).
Note: The H5CC is factory-set for timer operation.
H5CC
TIMER
1234
1234
0.00
0.00
tim
func
UP1+UP6 or DW1+DW6
(Press and hold for 2 s)
UP1+UP6 or DW1+DW6
(Press and hold for 2 s)