Omron HBP-1320 - Page 13

13
PM-1795-01-06/2018
• For the AC adapter connected to the unit, supplies, and optional devices, use only
the standard accessories or OMRON-specified products. This may damage and/or
may be hazardous to the device.
• Do not use in a location with moisture, or a location where water may splash on the
unit.
• This unit is intended for use in physicians’ office, hospitals, clinics and other medical
facilities.
• Do not use the unit if it emits smoke, an abnormal odor, or abnormal noise.
• Do not bring cellular telephones or transceivers into the room where the unit is
installed or being used.
• Do not connect multiple monitors to the same patient.
• Do not connect the unit to a power outlet that is controlled by a wall switch.
Cautions
• Before using the unit, verify that none of the following apply to the patient:
- Poor peripheral circulation, noticeably low blood pressure, or low body temperature
(there will be
low blood flow to the measurement position)
- The patient uses an artificial heart and lung (there will be no pulse)
- The patient has a mastectomy
- The patient has an aneurysm
- The patient has frequent arrhythmia
- Body motions such as convulsions, arterial pulsations, or trembling (cardiac
massage in progress, minute continuous vibrations, rheumatism, etc.)
• Before use, visually inspect the unit to make sure there are no deformations due to
falling, and that there is no dirt or moisture on the unit.
• When the unit has not been used for an extended period of time, always verify that
it operates normally and safely before use.
• Do not use in a location where the unit may easily fall. In the event that the unit falls,
verify that it operates normally and safely.
• Do not wrap the cuff on an arm with an SpO2 sensor or other monitoring equipment
attached. The pulse may disappear when the cuff pressurizes, causing a temporary
loss of monitoring function.
Cleaning
Warnings
• When cleaning the unit, turn off the power and disconnect the AC adapter from the
unit.
• After cleaning the unit, make sure it is completely dry before connecting to a power
outlet.
• Do not spray, pour, or spill liquids into or onto the unit, accessories, connectors,
buttons, or openings in the housing.
Cautions
• Do not use thinner, benzene, or other solvents to clean the unit.
• Do not sterilize by autoclave or gas sterilization (EOG, formaldehyde gas, high-
concentration ozone, etc.).