3. Using the Device
25
3.6
Initial Setting of the Monitor
To delete all the information stored in your monitor, follow the instructions below. Make
sure that the monitor’s power has been off.
1. While holding the button down, press
the START/STOP button for more than 5
seconds.
2. Release the and START/STOP button when
“CLr” appears on the display.
The “CLr” will appear on the display when your monitor has been initial
setting.
3. Press the START/STOP button to turn the monitor off.
The monitor will automatically turn off after 10 seconds even forgetting the off the
monitor.
Notes:
• Initial setting of the monitor will not delete the information in the app.
• The monitor will automatically turn off after 2 minutes.
HEM-7280T-AP_B_M.fm Page 25 Tuesday, October 13, 2015 2:51 PM
To Next Page
Loading...
Need help?
General
