SELECTING THE USER ID
Select your USER ID. Always use the same USER ID when taking a
measurement. The monitor stores the measurement values in the
memory by the USER ID selected. These measurement values are used
to calculate the Morning Averages and Evening Averages.
Slide the USER ID Selection Switch right or left to select USER A or B.
USING THE USER ID
When you select a USER ID the monitor can be set to take one
measurement using the Single Mode or three consecutive measurements
using the TruRead
TM
Mode when you press the START/STOP button.
NOTE: The default value is set to the Single Mode to take one
measurement. Refer to “Setting TruRead
TM
”.
TAKING A MEASUREMENT
32
To Next Page
Loading...
