USING THE GUEST MODE
The monitor is designed to take measurements and store the
measurement values in the memory for one person. The monitor can also
be used to take a single measurement for other persons using the GUEST
Mode. Measurements taken using the Guest Mode are not stored in the
memory.
1. Press and hold the START/STOP button for 3
seconds.
The Guest Symbol ( ) appears on the
display.
2. Release the START/STOP button.
The cuff starts to inflate automatically.
NOTE: To stop the inflation, press the START/STOP button. The
monitor will stop inflating, start deflation and turn off.
3. Inflation stops and the measurement is started. When the measurement
is completed, your blood pressure and pulse rate appear on the display.
TAKING A MEASUREMENT
30
To Next Page
Loading...
