Continue to press button
• If your systolic pressure is known
to be more than 220 mmHg, press and
hold the START button until the monitor
inflates 30 to 40 mmHg higher than your
suspected systolic pressure.
NOTE:
Do not apply more pressure
than necessary.
The monitor will not inflate
above 280 mmHg.
Instructions for special conditions:
HOW TO TAKE A READING
(Continued)
4. When the measurement is complete, the arm cuff
completely deflates and your blood pressure and
pulse rate are displayed.
NOTE:
The monitor automatically stores blood
pressure and pulse rate into the memory.
• When 21 sets of readings are stored
in memory, the oldest set will be deleted
to store a new set.
5. Press the ON/OFF button to turn the monitor off.
NOTE:
If you forget to turn the monitor off,
it will automatically shut itself off
after five minutes.
To Next Page
Loading...
Need help?
General
