Omron M2 Eco - Troubleshooting and Error Resolution; Understanding Error Messages

28
5.Handling Errors and Problems
5. Handling Errors and Problems
5.1 Error Messages
Error Display Cause Remedy
Cuff is under inflated.
Carefully read and repeat the steps
listed under section 3.4.
Movement during
measurement
Repeat measurement. Remain still
and do not talk during
measurement.
Refer to section 3.3.
Air plug disconnected.
Insert the air plug securely.
Refer to section 3.2.
Arm cuff not applied
correctly.
Apply the arm cuff correctly.
Refer to section 3.2.
Clothing is interfering with
the arm cuff.
Remove any clothing interfering
with the arm cuff.
Refer to section 3.2.
Air is leaking from the arm
cuff.
Replace cuff with new one.
Refer to Chapter 7.
The arm cuff was inflated
above 299 mmHg when
inflating the cuff manually.
Release your finger from the O/I
START button before the pressure
reaches 299 mmHg, when inflating
the cuff manually.
Refer to section 3.4.
Battery power is low.
Replace all four “AA” batteries with
new ones.
Refer to section 2.1.
Blinks or appears
continuously
HEM-7051_EN-RU.book Page 28 Thursday, January 8, 2009 9:09 AM