Omron M3 Intellisense User Manual

9
2.Preparation
EN
Battery Life & Replacement
If the battery low symbol ( ) appears on the display, replace
all four batteries at the same time.
-
When the battery low symbol ( ) starts to blink, you will still
be able to use the unit for a short while. You should replace
the batteries with new ones ahead of time.
-
When the symbol ( ) remains lit, the batteries are
exhausted. You should replace the batteries with new ones
at once.Turn the unit off before replacing the batteries.
•
Remove the batteries if the unit will not be used for three
months or more.
•
If the batteries have been removed for more than 30 seconds,
the Date/Time setting will need to be reset. See “2.2 Setting
the Date and Time” for details.
•
Dispose of batteries according to applicable local regulations.
Four new
“AA” alkaline batteries will last for approximately
1500 measurements, when used to take two measurements a
day.
Since the supplied batteries are for monitoring use only, they
may have a shorter life and not last for 1500 measurements.
HEM-7051_E_main.book Page 9 Friday, August 29, 2008 11:24 AM

Omron M3 Intellisense Specifications

General

Model	M3 Intellisense
Category	Blood Pressure Monitor
Cuff Size	22-42 cm
Memory Capacity	60 readings
Display	LCD
Power Source	4 x AA batteries
Clinically Validated	Yes
Average Reading	Yes (last 3 readings)
Measurement Method	Oscillometric
Measurement Range (Pressure)	0-299 mmHg
Features	Irregular Heartbeat Detection
Measurement Range (Pulse)	40-180 bpm
Number of Users	2