10
2.Preparation
2.2
Setting the Date and Time
Your blood pressure monitor automatically stores up to 42
measurements values in its memory and calculates an average
value based on the three most recent measurements taken
within 10 minutes of the last reading. (If there are only two
readings in memory for that period, the average will be based
on two readings. If there is only one reading in memory for that
period, that reading will be displayed as the average value.) To
make use of the memory and average values functions:
•
Set the unit to the correct date and time before taking a
measurement for the first time.
•
If the batteries have been removed for more than 30 seconds,
the Date/Time setting will need to be reset.
1.
When the O/I START button is
pressed to turn the unit on for
the first time after inserting
batteries, the year digits
(2005) will flash on the
display.
2.
Press the MEMORY button to
advance the digits one at a
time.
Notes:
•
The range for the year
setting is 2005 to 2030. If the
year reaches 2030, it will
return to 2005.
•
If you hold down the
MEMORY button, the digits
will advance rapidly.
HEM-7051_E_main.book Page 10 Friday, August 29, 2008 11:24 AM
To Next Page
Loading...
Need help?
General
