➊ Prepare the unit
Open the battery compartment and insert batteries.
Ensure polarity (+/-) of the batteries is correct.
Insert air tube to air jack (on the left side of the
device). The cuff must be airless.
➋ Switching on the unit
When you press the ( ) button all the symbols on
the display light up for approximately two seconds in
order to check the display.
Then all the symbols disappear and the air release
symbol ( ) begins to flash.
When preparations for measurement are complete
the ( ) symbol appears in the display to indicate
that the monitor is ready.
Air Jack
Air Plug
(Connects
to the
air jack)
Measuring your
blood pressure
English
5
To Next Page
Loading...
