Omron NJ Series

7. Connection Procedure
17
E-CAT is displayed on the
sub-display.
Press the ↑ (UP) Key once and
blink EIP on the sub-display.
Press the ZERO/SET Key.
*The memory link function
setting changes to EtherNet/IP.
Hold down the Mode switching
Key for two seconds.
Press the ↑ (UP) Key once.
EIP is blinking.
Press the ZERO/SET Key.
Hold down the Mode switching Key for
two seconds.
18
The confirmation screen for
mode switching is displayed.
Press the ZERO/SET Key.
The save confirmation screen is
displayed.
Press the ZERO/SET Key.
The RUN mode screen
displayed.
Press the ZERO/SET Key once.
Press the ZERO/SET Key once.
19
Cycle the power supply to the
Displacement Sensor.
*The new settings will take effect
after restarting.
<Setting range>
None/EIP/E-CAT
Default: E-CAT
25