Omron NJ Series - Page 27

7. Connection Procedure
15
Press the → (RIGHT) Key and
change the main display content
to SUB2 to SUB4.
Press the ZERO/SET Key to
check the setting values.
Confirm that the values of SUB2
to SUB4 are as follows:
•SUB2, SUB3: 255
•SUB4: 0
*In steps 14 and 15, you set
subnet mask 255.255.255.0.
After checking, press the
ZERORST/ESC Key three
times.
Press the ZERORST/ESC Key three
times.
16
ETN is displayed on the main
display.
Press the → (RIGHT) Key and
change the main display content
to DELIMI.
Press the → (RIGHT) Key and
change the main display content
to MEMKNK.
Press the ZERO/SET Key.
Press the → (RIGHT) Key once.
Press the → (RIGHT) Key once.
Press the ZERO/SET Key once.
24