Omron NX Series Network Connection Guide

5 Target Devices and Device
9
This section describes the procedure for using the Intelligent Tap to make an IO-Link
connection to the safety light curtain.
In this document, the IO-Link Master Unit is mounted on the same CPU as on the NX-series
Controller.
5.3.1 Operating Procedure
7. Mounting the IO-Link Master Unit Perform installation and wiring of the IO-Link
Master Unit.
▼
7.1 Mounting the IO-Link Master Unit Mount the IO-Link Master Unit on a DIN Track.

7.2 Wiring the Terminals Wire the Intelligent Tap to the IO-Link Master Unit.

8. IO-Link Master Unit Communications
Setup
Make the settings for performing communications
on an IO-Link System.
▼
8.1 Setting Up the System Configuration Start up Sysmac Studio, and set up the system
configuration that includes the IO-Link Master Unit.
This document describes a setup method in the
offline mode.

8.2 IO-Link Master Unit Settings Set up the IO-Link Master Unit.
▼
8.2.1 How to Use IO-Link Master Simple
Settings
Set up the I/O ports and device variables to be
used by the IO-Link Master Unit.
8.2.2 Setting Device Variables
▼
8.3 Transferring the Project Data Place Sysmac Studio online, and transfer the
project data to the controller.

9. Checking IO-Link Communications Make sure that cyclic communications are being
executed on the IO-Link System.
▼
9.1 Checking the Connection Status Check the connection status of each device.
▼
9.2 Checking Receive Data Make sure that the correct data is being received.
5.3 IO-Link Connection Procedure
Additional Information
Descriptions in this document presume that the controller and IO-Link Master Unit are in
the factory default state. For details on initialization of devices, refer to 11. Initialization
Method.

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English