Omron POWLI - UPS Settings Access; Accessing and Changing UPS Settings

40
4. UPS functions
(1)Whenthebeeperstopswitchisbrieypressed(forlessthan1second),thenextitemisdisplayed.
(2) The unit enters the “individual item setting mode” when the beeper stop switch is pressed and held
(for more than 1 second).
(3) When the power switch is turned OFF, the setting mode quits and the unit enters power switch OFF
status (status No.2).
Cold start ON/OFF setting
Output voltage setting
Power supply output stop delay time setting
Signal input/output test
BEEP STOP/TEST
BYPASS
BATTERY
WEAK
OUTPUT
The UPS operation mode can be set if the power switch is turned ON while the beeper stop switch is
pressed.
Note: While in setting mode, output from the power supply output is OFF even if the power switch is
ON.
2-2 Settings