To Next Page
R
Ryan WallaceAug 9, 2025
Why won't the Omron Controller motor rotate after entering the run command?
- HHoward MillerAug 9, 2025
The motor may not rotate after entering the run command for several reasons. The drive might not be in Drive Mode, indicated by the keypad not showing [Rdy]. Ensure the keypad displays [Rdy] or return to the Home screen. A fast stop command could have been received; if so, turn off the fast stop input signal. The settings for the Run command source (b1-02) or the frequency reference source (b1-01) might be incorrect, so verify these settings. Defective wiring in the control circuit terminals or incorrect voltage/current input settings for the master frequency reference could also be the cause. Also, check if the frequency reference is too low, and if so, increase it above the minimum output frequency (E1-09). Finally, confirm the sinking/sourcing mode and power supply settings are correct.
General
