Omron SCARA Robots YRCX Series - 10.1 Making settings

10
Disabling an option unit
24
10.1 Making settings
An option board can be disabled either from the programming box or from SCARA-YRCX Studio support
software.
10.1.1 Using the programming box
Step1
Open the Parameter Edit screen.
At the initial screen, select [Edit], press [Enter], then select [Parameter].
Step2
Press the [F6] (OPTION) key to display the Option Parameters screen.
Step3
Select the desired parameter.
Use the cursor up/down keys to select the parameter to be edited, then press the [F1] (EDIT) key.