Omron SJDE-APA-OY - Connector for Power Supply;Regenerative Unit (CNA)

3.8 Wiring the Power Supply/Regenerative Unit Connector (CNA)
31
5. Connect the connector to the SERVOPACK.
After wiring the connector, reconnect the connector to the SERVOPACK.
Note: 1. Pull lightly on the wires to confirm that they are securely connected.
2. Be sure that none of the insulating sheaths of the wires are caught in the springs.
 Connector for Power Supply/Regenerative Unit (CNA)
Pin No. Symbol Signal Name
1L1
Power supply input terminals
2L2
3+
Regenerative unit connection ter-
minals
4 −
Power supply/Regenerative Unit connector
JZSP-CHG9-1
(This connector is supplied with the servopa
c
Power supply
Single-phase, 200 VAC
Molded-case circuit breaker
Noise filter
Magnetic contactor
AC reactor
Regenerative Unit
CNA connector
FuseFuse
+(Y3)
—
Y4
Y5
C1
C2
1
2
3
4
L2 L1
TOEP_C710806_01A_0_0.book Seite 31 Montag, 2. Juli 2007 4:24 16