Omron SYSMAC NX-CIF105 - Page 196

Appendices
A - 16
NX-series Communications Interface Units User’s Manual (W540)
• The following table gives the meanings of the set values for the Ch1 Initial RS Signal Value.
• The following table gives the meanings of the set values
for the Ch1 Start Serial Line Monitor.
• The following table gives the meanings of the set values
for the Ch1 Stop Serial Line Monitor.
Index
(hex)
Subindex
(hex)
Object name Default Data range Unit
Data
type
Access
I/O allo-
cation
Data
attri-
bute
500B --- Initial RS Signal Value --- --- --- --- --- --- ---
01 Ch1 Initial RS Signal
Value
0 0 or 1 --- USINT RW No Y
Set value Description
0 OFF
1 ON
Index
(hex)
Subindex
(hex)
Object name Default Data range Unit
Data
type
Access
I/O allo-
cation
Data
attri-
bute
5011 --- Start Serial Line Moni-
tor
--- --- --- --- --- --- ---
01 Ch1 Start Serial Line
Monito
r
---
0 to 2
*1
*1. You can write 1 or 2 as the set value. If you read the value, a value of 0 is always read.
--- BYTE RW No ---
Set value Description
1 Set continuous monitor mode and start monitoring.
2 Set one-shot monitor mode and start monitoring.
Index
(hex)
Subindex
(hex)
Object name Default Data range Unit
Data
type
Access
I/O allo-
cation
Data
attri-
bute
5012 --- Stop Serial Line Moni-
tor
--- --- --- --- --- --- ---
01 Ch1 Stop Serial Line
Monitor
---
0 or 1
*1
*1. You can write only 1 as the set value. If you read the value, a value of 0 is always read.
--- BYTE RW No ---
Set value Description
1 Stop monitoring.