Omron V600 - Page 119

RFID System
User's Manual
Section 6 Specifications and Dimensions
Section 6
Appendices
117
Communications Specifications
•Host Communications Interface Specifications
V600-CHUD
Use the host communications interface as the COM port for the host device.
V600-CH1D-V2
Note 1: For conversion to a 25-pin connector, use the SGC-X9P/25P-2 manufactured by Sunhayato, or
an equivalent.
Note 2: Set by a settings command.
Item Specification
Connectors (connector
connection status)
Series A plug
USB specifications Ver 1.1
Baud rate Full speed (12 Mbps)
Device class COM class
Vendor ID Hexadecimal format [0590]
Product ID Hexadecimal format [0048]
Item Specification
Connector D-Sub 9-pin (applicable to IBM PC/AT or compatible) (See note 1.)
Standard compliance RS-232C
Transmission line
connection
1:1
Communications
method
Two-wire, half duplex
Synchronization
method
Asynchronous (stop bit: 1 or 2) (See note 2.)
Baud rate 2,400, 4,800, 9,600, 19,200, 38,400 bps (See note 2.)
Transmission code 7-unit ASCII or 8-unit JIS (See note 2.)
Communications
control
1:1
Error detection Vertical parity (even/odd/none) (See note 2.)