Omron V600 - End Code List

95
RFID System
User's Manual
Section 3
l
End code List
Section 3
Commands
End code List
End codes are indicated in 2-digit hexadecimal code.
Note 1: A 7B error code response indicates that the command was completed normally, but the battery
voltage is low. If the battery voltage is so low that a response cannot be returned, an error
code such as 72 will be returned.
2: Vertical parity errors, framing errors, and overrun errors do not occur for the V600-CHUD.
For details on each error, refer to Error Tables.
p.112
Status End code Meaning
Normal 00 Normal completion
7B Battery low warning indicating that battery replacement is required (See note 1.)
Host communications error 10 (See note 2.) Vertical parity error
11 (See note 2.) Framing error
12 (See note 2.) Overrun error
14 Format error
15 Execution status error
18 Frame length error
Lower communications error 70 Data Carrier communications error
71 Mismatch error
72 Data Carrier non-existent error
76 Data error
7A Address error
7C Antenna error
7D Write protect error
Memory error
93 (See note 2.) EEPROM memory error