90
Section 3 Controller Control Commands
RFID System
User's Manual
Section 3
Commands
Controller Control Commands
These commands are used to reset the Controller or set serial communications.
ABORT (XZ)
This command is used to restore the Hand-held Reader Writer to command wait status when there is
no response from the Hand-held Reader Writer due to some problem during communications with the
host device or with a Data Carrier.
The ABORT (XZ) command can be used only with the V600-CH1D-V2.
Do not use it with the V600-CHUD.
None
Command
XZ
2
2
CR
Command
code
Terminator
Response
To Next Page
Loading...
