Omron V600 - Communications with the Data Carrier

40
Section 3 Communications with the Data Carrier
RFID System
User's Manual
Section 3
Commands
Communications with the Data Carrier
There are 4 types of commands for communicating with the Data Carrier using the Hand-held Reader Writer.
•Normal commands
•Button commands
•Auto commands
•Button auto commands
Normal Commands
Normal commands are sent from the host device for communications with the Data Carrier, after the
antenna end of the Hand-held Reader Writer has been moved close to the Data Carrier.
1. Move the antenna end of the Hand-held Reader Writer close to the Data Carrier.
2. Commands are sent from the host device to the Hand-held Reader Writer.
3. The Hand-held Reader Writer communicates with the Data Carrier.
4. A response is returned from the Hand-held Reader Writer to the host device.
If communications are normal, the operation indicator (LED) lights green and then turns OFF.
If the Data Carrier is not detected within the Hand-held Reader Writer's communication area when the
command is sent from the host device, a Data Carrier Non-existent Error will occur.
At this time, the operation indicator will flash red.
Res
p
onse
Communications
with Data Carrier
Command
1
2
4
3
Host device
Hand-held Reader Writer
Data Carrier