12
Section 1Names and Functions of Components
RFID System
User’s Manual
Section 1
Product Overview
V600-CH1D-V2
•Operation Indicator (LED)
After the operation indicator is lit or flashing for a certain time, it will turn OFF.
•Activate Switch
When button commands (button commands, button auto commands) are
used and the activate switch is pressed, communications with the Data
Carrier will commence. (For details on button commands, refer to Section
3 Commands.)
When the activate switch is pressed with the Hand-held Reader Writer in
the initialization stand-by mode (with the green LED flashing) the function
settings will be initialized.
•Reset Button
Press this button for two seconds or more when the power is first turned
ON to put the Hand-held Reader Writer into the initialization stand-by
mode.
•AC Adaptor Connection Jack
This is a connection jack for the V600-A22 AC.
•Serial Interface Connector
This is a serial interface with an RS-232C-compliant D-Sub 9-pin connec-
tor.
•Antenna
To communicate with the Data Carrier, move the antenna head closer to it.
Display Meaning
Lit green
A command has been received from the host device.
Communications with the Data Carrier have completed normally.
Flashing green
• When the power is turned ON, after initialization of the Hand-
held Reader Writer is completed
• When the power is turned ON and the reset button is pressed for
two seconds or more (initialization stand-by mode).
Communications with the Data Carrier are in progress.
Lit red
A communications error with the Data Carrier has occurred.
A CPU error has occurred.
Flashing red
A Data Carrier non-existent error has occurred.
A communications error with the host device has occurred.
Antenna
Operation indicator (LED)
Activate switch
Serial interface
connector
AC Adaptor
connection jack
Reset button
To Next Page
Loading...
