Omron V600 - Page 47

45
RFID System
User's Manual
Section 3
l
Command and Response Format
Section 3
Commands
•Hexadecimal Code
•One character is treated as a hexadecimal number. Therefore, only numerals 0 through 9 and A to F
can be accepted.
•Two characters of data occupy 1 byte (1 address) of the Data Carrier memory. Therefore, specify data
in 2-character units (in even numbers) when using a WRITE command. If an odd number of charac-
ters is specified by mistake, an error will occur.
Address
0010
0011
1 b
y
te
9
1
9
6
•Data Carrier
•Example of Specifying Hexadecimal Code
WT 10H1
Start address
00 9619
Write data Terminator
Command
code
Hexa-
decimal
code
setting
Process-
ing area
number
setting
CR