Omron W4S1-0 Series User Manual

Rev. 1.0
8
9
Set the GI nodes IP address
Note: Use clear memory
function if below does not
seem to work. Changing IP
address is sometimes not
allowed if TUNID is set. Z400
section 6-4-3
Mode 0: 192.168.250.x x
set by x16 and x1
Mode 4: DHCP see manual
Z400
10
To program the GI
11
Set target node IP address –
to match the I/O block rotary
set IP address

Omron W4S1-0 Series Specifications

General

Brand	Omron
Model	W4S1-0 Series
Category	I/O Systems
Language	English