16
EN
To clear all of the set values and measured results
(past measurement results), initialize your main unit
as follows.
1 Press and hold and at the same time.
The “lb” or “kg” flashes on the display.
2 Press and hold and at the same time again.
After “Clr” has been displayed, “lb” and “kg” flash on
the display.
Notes:
• To continue using the unit, reset the weight, height,
stride length and time (refer to “ACTIVATION AND
INITIAL SETTING” starting at A. Setting the unit of
measurement on page 8).
• If no settings are made for more than 5 minutes, the unit
will revert to the factory mode.
DELETE ALL SETTINGS
To Next Page
Loading...
