Omron Walking style IV - Initial Setup; Setting Measurement Units; Personal Data Configuration

8
EN
When you use the unit for the first time, follow the steps
below.
Press any button for 2 seconds.
After the following display, “lb” and “kg” flash on the display.
A. Setting the unit of measurement:
Weight, Height/Stride Length, Distance.
(lbkg, feet/inchcm, milekm)
1 Setting the weight unit.
(1) Press or to select the desired value for a
setting.
(2) Press to confirm the setting.
2 Repeat steps (1) to (2) to set the height/stride length
unit.
3 Repeat steps (1) to (2) to set the distance unit.
Setting range details refer to “TECHNICAL DATA” on
page 20.
B. Setting the Weight, Height, Stride Length and Time.
1 Setting the weight.
(1) Press or to select the desired value for a
setting.
• Press ( ) to advance (go back).
• Hold
( ) down to advance (go back) rapidly.
(2) Press to confirm the setting.
2 Repeat steps (1) to (2) to set the height.
3 Repeat steps (1) to (2) to set the stride length.
4 Repeat steps (1) to (2) to set the time.
This completes the setup.
ACTIVATION AND INITIAL SETTING
NOT FOR PRINTING