Omron ZFX-C - Page 17

About Communication Commands
ZFX-C Serial Communication Command Reference
15
Executing Measurement < MEASURE command >
Executing a Single Measurement
This command executes a single measurement.
< Command format >
< Response format >
< Explanation of parameters >
Measurement values are output only when an expression is set at [Setup] - [Support] - [Calculation] - [Data], and [RS-
232C/422] or [USB] is specified at [System] - [Output] - [Data output].
Measurement value The acquired measurement value is returned. The measurement value is output in the
format (ASCII/binary) specified in the output conditions.
Configuration of Measurement Value Data p.8
M EAS
C
R
M
C
R
URE
or
O K
C
R
E R
C
R
C
R
When processing ends successfully
When processing fails
Measurement value
Important