About Communication Commands
ZFX-C Serial Communication Command Reference
27
Uploading Bank Data < BNKLOAD command >
Uploading bank data to the Controller from an external device
This command uploads the bank data to the Controller by XMODEM protocol.
< Command format >
< File transfer >
The bank data is transferred by XMODEM (-CRC or SUM) after READY is received. XMODEM (-1K) is not
supported.
< Response format >
< Explanation of parameters >
Uploading bank data to the Controller from an SD card
This command uploads bank data to the Controller from an SD card.
< Command format >
< Response format >
< Explanation of parameters >
Bank No. Specifies the bank No. to upload. (0 to 31)
Bank No. Specifies the bank No. to upload. (0 to 31)
File name Specifies the file name within eight alphanumeric characters. (An extension is not
required.)