1
This manual is the designated user guide for the installation, setup, safe operation, and maintenance of your ber
laser marking machine.
All personnel involved in the installation, setup, operation, maintenance, and repair of this machine should read
and understand this manual, particularly its safety instructions. Substandard performance and longevity, property
damage, and personal injury may result from not knowing and following these instructions.
Your laser marking machine works by emitting a powerful laser beam from its ber laser source, sending that beam
through a ber optic cable, focusing its power through the galvanometer lens, and using this focused light to etch
designs into certain substrates.
This laser marking machine uses a nanoscale ber laser source. Its single-mode output, good heat dissipation, high
eciency, and compact structure make it ideal for high-precision laser marking.
With typical use, this machine has an average lifespan around 100,000 working hours. However, constantly running
your laser above 80% of its maximum rated power can signicantly shorten its service life. It is recommended to use
settings from 10–75% of the maximum rated power to enjoy optimal performance and longevity.
Note that this is a high-voltage machine and, as a safety precaution, it is recommended to only touch its components
with one hand at a time during use.
Note also that this machine does not have a protective housing. It is thus recommended to use a special room or to
raise protective screens around the work area. The active laser is invisible to the human eye and anyone in or near the
working area MUST use special protective eyewear when the laser is in use to avoid potentially permanent injury.
1.1 General Information
1. Introduction
To Next Page
Loading...
Need help?
General
