Onan 6GO-F - Page 75

If it is desired to connect a remote start-stop control switch, connect
the switch terminals Nas. I, 2, and 3 to the corresponding terminals,
marked REMOTE, behind and below the control panel.
Page. 9 - Add the follo'Ving information to that given under STARTING THE
PLANT MANUALLY.
The magneto ignition plant' has a momentary contact toggle switch which
by-passes the low oil pressure cut-out switch. Hold this toggle switch
in contact while cranking the engine and until the oil pressure has
built up to nor.mal running pressure. Manual carburetor choking is pro-
vided on the magneto ignition plant.
Page 2l - Add the following information to MAINTENANCE A!.'JD REPAIRS.
STARTER iU'lD BATTERY CHARGING GENERATOR.- When servicing the starting
motor and small battery charging generator, follow the same general
principles of maintenance and repairs as given for the main generator.
Page 29 - Paragraph headed COMMUTATOR AND COLLECTOR RINGS, line 1.
Delete reference to collector rings.
Paragraph headed BRUSHES, line 5. Delete referencf:) toAC
springs.
Page 28 - SUbstitut,; the illustration, DlllliCT CUH.H.c;r~T GEi~ERATOh ASSJ9liBLY
for the ALTERNATING CURRENT GENERATOR ASSEMBLY illustration.
ARM,ATUAt DR1VE HUB 01SC.
F'-VWK~t\. HOU$lN.
FLYWHEEL
·
AAM' DRlv[ Dl6~ MUB
ARMA"fuAJ:
. ,
,:0:, '
,
8
~
DIRECT CURRENT GE:NE:RATOR" ASSEMBLY
69
J