Appendix A.
Troubleshooting Guides
The following pages contain simplified troubleshooting procedures for these Marquis electronic components:
Subject Page
Emerald/Marquis Control Boards 300-3763-01 and 300-3763-02 . . . . . . . . . A-2, A-3
Performer/Emerald Plus/Marquis/Ensign Electronic Ignition Module . . . . . . . A-4
Marquis Control Board Check-Out . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-5, A-6
Use a volt-ohmmeter and a test light with these procedures to test Marquis control circuit boards for proper
functioning.
Two Onan product support bulletins are also reprinted in this supplement, as follows:
Subject Page
"Set Dies When Switch Released" (PSB #563)
.......................
A-7
"Rotor/Stator Check" (PSB #564)
..................................
A-8
IAWARNINGI
The steps described In this appendix are intended
as
quick
reference guides, rather than
complete procedures. Consult the appropriate sections
of
this manual before using the
procedures found In this Appendix.
Incorrect service
or
parts
replacement can result In severe persona/Injury, death, and/or
equipment damage. Service personnel
must
be qualified to perfonn electrical and/or me-
chanical service.
To Next Page
Loading...