www.onbonbx.com Page 18
USER MODE SAVE AND SWITCH
Mode save
Press “SAVE” on board, as below:
Select the save mode you want, then, click【OK】.
Note:
（1）If the circle is solid, means the present mode data is already there; If the circle is hollow,
means the present mode data is not there.
（2）Maximum 8 user modes, it saves image size, position,status and brightness, contrast.
（3）If users changed splicing mode, the saved user modes will be deleted.
User mode switch
Press “LOAD” on board, as below:
Note:
（1）Can be switch only if you saved before.
（2）If you already save, you can use it by pressing 1-8 numbers.
To Next Page
Loading...
Need help?
General
