ONE100 Chapter 3
Installation Guide Device Description
28
Aux Green When the LED indicates the status of the CWMP function:
• OFF: CWMP (CPE WAN Management Protocol) not configured.
• ON - green: CWMP update successful.
• Blinking green 3s ON / 3s OFF: CWMP in progress.
• Blinking green 1s ON / 1s OFF: CWMP update has failed.
• Blinking green 0,25s ON / 0,25s OFF: TR-69 annex F error.
When the LED indicates the status of the auto-update function:
• OFF: No auto-update configuration
• Blinking Orange: auto-update in progress
• Green: auto-update successfully completed
• Blinking Red: auto-update failure
Com Multicol-
our
• OFF: No voice service on any of the voice ports.
• ON - Green: Voice service operational on any of the voice ports.
• Blinking green: No default at least one voice call in progress.
• ON - Red: Voice service not fully operational (Gateway deregis-
tered or no more configured voice port or layer1 on BRI/PRI inter-
face is down or no configured dial-peer voip).
• ON - Orange: Specific status when Voice Test service is config-
ured and it did not work at the end of installation (no gateway avail-
able and only local call available).
The behaviour can be changed by using the
voice led track-conditions CLI command.
Refer to the ONEOS V5.2 Voice Over IP User Guide for more infor-
mation.
1. An IP interface is a physical or logical interface (e.g. ATM PVC, PPP session, VLAN) which is
configured for IP traffic (routed mode).
An IP interface is up if its interface is up on layer 2 and it has either obtained a dynamic IP
address (e.g. from IPCP or DHCP) or a static IP address is configured.
If the IP or PPPoE/PPPoA session is dropped due to an idle or lease timeout, the LED will
remain green if the layer 2 is still present on this interface. If the session is dropped for any
other reason, the LED is turned off.
LED name Colour Description
To Next Page
Loading...
