OneAccess ONE100 - Led States

ONE100 Chapter 3
Installation Guide Device Description
27
3.4.2 LED States
The state of the LEDs indicate the following:
LED name Colour Description
Status Bicolour • OFF: No input power.
• ON - green: Switched on and operational.
• ON - red: Switched on and not operational.
• Blinking green: (Re)boot in progress.
Uplink Bicolour On a ONE100E, the uplink interface is port 1/0. Possible LED states
are:
• OFF: The Ethernet port 1/0 is not configured or not up.
• ON - green: The Ethernet port 1/0 is up.
• Blinking green: Traffic in progress.
On the ONE100G/D/M, the uplink interface is the SHDSL interface.
Possible LED states are:
• OFF: The SHDSL interface is not configured.
• ON - green: The SHDSL interface is synchronised. At least minAc-
tiveLinks (default = 1) are in use.
• ON - red: The SHDSL interface does not get any reaction from the
other side of the SHDSL link on any of the line pairs.
• Blinking green: The SHDSL synchronisation is in progress. Less
than minActiveLinks (default = 1) are yet synchronised in case of
EFM or IMA on the SHDSL link.
IP Bicolour • OFF: not used.
• ON - green: All IP interfaces on the SHDSL or backup link are up
1
.
In case of bridging, the layer 2 is up on the SHDSL link.
• ON - red: Layer 2 down or all IP interfaces on the SHDSL link are
down in case of routing.
• Blinking green: At least one IP interface is up and at least one is
not up on the active uplink. Not applicable if no routing is done.
WLAN Green • OFF: Not in use.
• ON - green: The WLAN interface is up.
• Blinking green: Traffic in progress.