ONE100 Chapter 4
Installation Guide Interface Description
47
4.3 LAN 4 port Ethernet Switch Specifications
• 4 port Ethernet switch with 10/100 Base T ports
• Connectors: RJ45 (EIA/TIA 568B)
Each UTP Ethernet port supports the following:
• Applicable standards:
- IEEE 802.3 10Mbps Ethernet Half Duplex or Full Duplex
- IEEE 802.3u 100Mbps Ethernet Half Duplex or Full Duplex
• 10/100 Mbps auto-sense
• Auto-negotiation
• Auto cross-over MDI/MDI-X for automatic connection to a terminal or switch
• The following LEDs are available built-in on each Ethernet connector:
• Cable to be used: standard Ethernet cable, minimum category 5
An Ethernet cable with label 4022 991 V00 is included with the device
• The following table shows the connector layout of the RJ45 Ethernet LAN interface connectors:
Colour Description
Green
(left
1
)
1. Defined as looking from the back.
• OFF: link inactive.
• ON: link active.
Yellow
(right
1
)
• OFF: no traffic in progress.
• Blinking: traffic in progress.
Pin Signal DTE DCE Figure
1 transmit (+) Out In
2 transmit (-) Out In
3 receive (+) In Out
4 not used -
5 not used -
6 receive (-) In Out
7 not used -
8 not used -
To Next Page
Loading...
