OneAccess ONE100 - LAN Interface Specifications

ONE100 Chapter 4
Installation Guide Interface Description
48
4.4 LAN Interface Specifications
• Connector: RJ45 (EIA/TIA 568B)
• Cable to be used: standard Ethernet cable, minimum category 5.
An Ethernet cable with label 4022 991 V00 is included with the device.
• Applicable standards:
- IEEE 802.3 (10Mbps Ethernet)
- IEEE 802.3u (100Mbps Ethernet)
• Speed: 10/100 Mbps auto-sense
• Auto cross-over DTE/DCE (MDI/MDI-X, for connection to a terminal or switch)
• The following LEDs are available built-in on each Ethernet interface connector:
• The following table shows the connector layout of the RJ45 Ethernet LAN interface connector:
Colour Description
Green
(left
1
)
1. Defined as looking from the back.
• OFF: link inactive.
• ON: link active.
Yellow
(right
1
)
• OFF: no traffic in progress.
• ON: traffic in progress.
Pin Signal DTE DCE Figure
1 transmit (+) Out In
2 transmit (-) Out In
3 receive (+) In Out
4 not used -
5 not used -
6 receive (-) In Out
7 not used -
8 not used -