ONE100 Chapter 4
Installation Guide Interface Description
55
4.9 Console Port Specifications
• Serial V.24 console interface
• Connector: RJ45 (EIA/TIA 568B)
• Data:
-RS232
- 9600 bps
- 8 data bits
- no parity
- 1 stop bit
The following table shows the connector layout of the RJ45 Console connector:
A console cable for router configuration and maintenance only requires TX, RX and GND to be con-
nected; refer to Annex A: - Console Cables on page 72 for more information about the cables.
Pin Signal DCE Figure
1TX Out
2RX In
3GND -
4NC -
5NC -
6NC -
7NC -
8NC -
To Next Page
Loading...
