ONE100 Chapter 6
Installation Guide Installing the ONE100
67
6.3.2 Wall Mounting a Device With a Plastic Housing
The bottom plate of the ONE100 has 2 notches in order to enable wall mounting. Refer to the figure
below, for the position of these notches. By installing two screws at the required distance, the device can
be hung on any vertical surface.
In order to do so, proceed as follows:
Step Action
1 Drill two holes in the wall, according to the following specifications:
• hole diameter: 4 mm
• distance between the holes: 244 mm
• hole depth: at least 25 mm
2 Insert two wall plugs in the holes. The plugs should have the following dimensions:
• diameter: 4 mm
• length: 20 mm
3 Screw in two screws in the plugs. Leave a distance of 5 mm between the wall and the
head of the screw.
4 Slide the ONE100 over the screws until it touches the wall, and gently push it down. If
necessary, adjust the screws in the notches of the device.
To Next Page
Loading...
