20 Oneida Air Systems
FAQ
How is the Mini Gorilla lter cleaned? I don't see the typical hand crank.
e use of hand cranks that "beat" the lter can damage the lter's pleating material overtime, so our systems are
not built with such systems. Please see the Maintenance section titled Cleaning the lter.
Can this be used for wet applications?
No. is system is designed for collecting dry materials only.
What dust can be collected?
Oneida Air Systems' dust collectors are designed and tested for wood and wood dust. ey can and have been be
used eectively for various other dusts and chips such as drywall dust, paper dust, agricultural dust, metal chips
and other forms of debris. e customer is however, cautioned that some common materials when cut, ground
or processed by machinery may become very dangerous: highly toxic, ammable, or deagrable and explosive
and they should therefore ensure that you use your particular use of a dust collection system in accordance to
national, state, local, NFPA, OSHA and all other applicable codes.
Can I wall mount my Mini Gorilla to the wall?
Currently, we do not have any wall mount solution available.
Is this product compatible with Quick-Clamp Duct?
Yes, but you will need both a 5" Female Hose Quick Connect (DQF050000) and a Machine Adapter
(GAM050000) into the dust collector's inlet. e Machine adapters are smaller on the raw end than traditional
ducting. A 5" Quick-Clamp Duct Machine Adapter will measure ~4.9" O.D. on the raw end.
How do I connect the Mini Gorilla to my tools?
e Mini-Gorilla's inlet measures 5" on the outer diameter, making it ideal for accepting raw (uncrimped)
ductwork ttings over the inlet such as reducers and quick-connects. Crimped ductwork will not usually t into
the inlet but can be done when necessary and secured in place with foil tape. Flex hose can also be pulled over
the inlet but will generally be a tight t.
What size tool ports will this work with?
e Mini Gorilla is optimized for use with tools that have a single 4" or 5" dust collection port. When using
the Mini Gorilla on smaller dust ports between 2"-3", performance will be reduced. If optimal performance is
required on port sizes smaller than 4", you should consider the Dust Cobra (#XCKM) or the Supercell (#XSK).
Both systems have high static pressure, which allows for better performance on smaller port sizes.
How many tools can I collect from simultaneously?
We recommend to run one tool with a 4" or 5" port at a time. If you have mutlitple tools connect to your system,
close o the ports to unused tools with blast gates when they are not in use.
To Next Page
Loading...
