onga Pantera II Series

Questions and Answers

K
kenneth75Aug 1, 2025
What to do if there is no water discharge in my Onga Water Filtration Systems?
- D
  Danielle LandryAug 1, 2025
  If your Onga Water Filtration System experiences no water discharge, it could be due to a couple of reasons. First, the pool water level might be too low; in this case, fill the pool to the correct level. Second, there might be air leaks in the inlet fittings to the pump. To resolve this, check and tighten all connections, and consider using Teflon tape on the fittings.
J
Jacob FarrellAug 8, 2025
Why is the filter startup pressure low and water flow high in my Onga Water Filtration Systems?
- D
  Dorothy JohnsonAug 9, 2025
  If the filter startup pressure is low and the water flow is high in your Onga Water Filtration System, several factors could be at play. Check if the skimmer basket is full of leaves or debris and clear it. Ensure the pump strainer lid is sealed correctly, referring to the pump owner's manual for the correct procedure. Verify that the pool water level is at the correct level. Other potential issues include a blocked pump impeller (in which case, call an authorized service agent), a blockage in the suction line, or an air leak in the suction line.
J
Jay SmithAug 17, 2025
Why are the filter cycles short in my onga Pantera II Water Filtration Systems?
- L
  Lisa HernandezAug 17, 2025
  Short filter cycles in your Onga Water Filtration System can occur for several reasons. The filter may be dirty, indicating it hasn't been backwashed for a long enough period. Alternatively, the media (sand or Zelbrite) may need replacing. Also, if there's algae present in the pool water, avoid running the filter with live algae. Check the chemical condition of the pool water, as incorrect chemical treatment can significantly shorten the filter cycle.
P
probinsonAug 25, 2025
What to do if the filter startup pressure is high and water flow is low in my onga Pantera II Water Filtration Systems?
- A
  Ashley RodriguezAug 25, 2025
  If your Onga Water Filtration System has a high filter startup pressure and low water flow, it could be because the filter requires backwashing. Follow the backwash procedure outlined in the manual. Also, check for any restrictions in the return line by verifying the flow at the return.

Summary

Model Data

Filter Application

Installation Procedures

Filter Internals Assembly

Steps for assembling the filter's internal components, including laterals and hub.

Loading Sand Media

Instructions on how to properly load sand media into the filter tank.

Multi-Port Valve Installation

Procedures for correctly installing the multi-port valve onto the filter.

Operation Guidelines

Multi-Port Valve Settings

Explains the various settings and functions of the multi-port valve.

Startup and Operation

Guides users through the initial startup and routine operation of the filter system.

Service and Maintenance

Weekly Equipment Checks

Routine inspections to ensure the pool equipment is functioning correctly.

Water Maintenance

Guidelines for maintaining proper water levels and pH balance in the pool.

Pool Vacuuming and Draining

Instructions for vacuuming the pool and adjusting water levels.

Valve Servicing and Removal

Information on servicing, troubleshooting leaks, and removing the multi-port valve.

Tank Assembly

Troubleshooting Guide

Product Warranty Information