20
Connections—Continued
The CD/HDD receiver has SUBWOOFER PRE OUT jack for connecting a powered active subwoofer (i.e., a subwoofer
with a built-in amplifier).
The following diagram shows how to connect a component with an optical digital audio output, such as a games console,
satellite tuner, or personal computer. Connect the CD/HDD receiver’s DIGITAL OPTICAL IN jack to an optical digital
audio output on the other component.
You can change the Input Display for the OPTICAL DIGITAL IN to DIGITAL, CD-R/dig, GAME/dig, or PC/dig so
that it matches the type of component that you connect (see page 45).
The CD/HDD receiver supports only a 16-bit PCM signal with a sampling rate of between 44.1 kHz and 48 kHz.
Some components require the settings of forced conversion to PCM.
Connect the CD/HDD receiver’s LINE 1 IN jacks to the TV’s audio output jacks.
Connecting a Subwoofer
Connecting a Component with a Digital Audio Output
Connecting a TV
: Signal flow
owere
act
ve
subwoofer
CD/HDD receiver’s rear panel
DIGITAL
OUTPUT
: Signal flow
Commercially available optical
digital audio cable (square)
Game console, etc.
Optical digital output
LR
Analog audio cable (RCA)
: Signal flow
Audio output
TV
Red White Red White
To Next Page
Loading...
