42
USB Device Playback—Continued
Removing the USB Device
1 Stop the playback and switch the input source to USB.
2 Hold down the Stop [2] button until “No USB” appears.
3 Disconnect the USB or USB cable from the CD/HDD receiver.
Do not disconnect the USB cable until you see the “No USB” message.
Basic Operations of Playback
1
Plug your USB device into the CD/HDD receiver’s USB port.
In the case of an iPod or digital audio player:
1. Connect the USB cable to the connector of the iPod or digital audio player.
2. Plug the USB cable into the CD/HDD receiver’s USB port.
The iPod or digital audio player automatically turns on. The
CD/HDD receiver may take
approximately one minute to recognize the iPod, so wait until the recognition is com-
pleted.
2
Switch the input source to USB.
Press the INPUT [q]/[w] buttons. You can
also use the [INPUT SELECTOR] button
to select the input source.
The track information appears on the dis-
play of the
CD/HDD receiver. (ONKYO
logo appears on the display of the iPod.)
3
Start playback.
Press the Play/Pause [1/3] or Play
[1] button.
Tip:
When you press the remote controller's
USB [1] button, the
CD/HDD receiver
automatically selects an appropriate input
source and starts playback of a track.
Playback starts with the first track of the
first folder.
INPUT
SELECTOR
INPUT
USB port
USB cable
CD/HDD
receiver
Remote
controller
or
1/ 1 00:00
Album name
Track01
Artist name
Track name Format
CD/HDD
receiver
Remote
controller
or
00:11
Album name
Track01
Elapsed time of current track
To Next Page
Loading...
