40
Listening to the Radio—Continued
Editing Characters
If the character input mode is not currently selected, per-
form steps 1 to 3 of “Naming Presets” on page 39.
1 Use the Left and Right [e]/[r] buttons to select a
character to be changed or deleted.
The character flashes.
2 To change the character:
Follow the steps 4 and 5 of “Naming Presets” on
page 39 to select a desired character.
To delete the character:
Press the [CLEAR] button.
3 Press [ENTER] to finish the change/deletion.
Pressing the [RETURN] button cancels the
change/deletion and displays the previous display.
Inserting a New Character
If the character input mode is not currently selected, per-
form steps 1 to 4 of “Naming Presets” on page 39.
1 Use the Left and Right [e]/[r] buttons to select
the character immediately after the insertion
point.
That character flashes.
2 Press the Up [q] button to display .
3 Enter a character to be inserted following step 5 of
“Naming Presets” on page 39.
4 Press [ENTER] to finish the insertion.
Pressing the [RETURN] button cancels the insertion
and displays the previous display.
Erasing a Preset’s Name
1 Switch the input source to FM or AM (see
page 24).
2 Press the Previous/Next [7]/[6] buttons to
select the preset whose name you want to erase.
3 Press the [TOOLS] button and then press
[ENTER] with “Tool” selected.
4 Use the Up and Down [q]/[w] buttons to select
“Name Erase”, and then press [ENTER].
5 Use the Up and Down [q]/[w] buttons to select
“OK”, and then press [ENTER].
“Complete!” will be displayed, and the preset name
has been erased.
To cancel the Name Erase function, press the Up and
Down [q]/[w] buttons to select “Cancel”, and then
press [ENTER].
Tool
A ] DEAM
Name In?
Tool
A ] DR
AM
Name In?
Tool
A ] DREAM
Name In?
To Next Page
Loading...
