52
Recording (Transferring Data)—Continued
FTP Connection
Via FTP connection, you can access the CD/HDD
receiver from your computer and transfer the data from
the HDD to computer and vice versa.
* Only for personal computers with Microsoft Windows XP Ser-
vice Pack 2, Service Pack 3, or Microsoft Windows Vista
installed.
Note:
Since the folder name and file name are treated as Uni-
code in the HDD, some folders and files may not be
selected.
Before operating
• Set the IP address on the CD/HDD receiver by refer-
ring to “Entering DHCP Settings Manually” on
page 69. If the IP address is not set, the FTP connec-
tion is not available.
• If a track is being played or recorded with the
CD/HDD receiver, stop the operation.
1
Press the [TOOLS] button.
2
Use the Up and Down [q]/[w] but-
tons to select “Network”, and then
press [ENTER].
3
Select “FTP” and then press
[ENTER].
HDD Personal computer
Utility
Network
Audio
FTP User name
FTP
Network
4
Select “Open?” and then press
[ENTER].
After “FTP Starting…” is displayed,
“FTP Stop” appears.
5
Start Windows Explorer on your
computer, access the CD/HDD
receiver by specifying the IP
address.
When Address Bar is not displayed on
Windows Explorer, display Address Bar
according to the Windows operation.
If a username and password have been
set in the CD/HDD receiver, also specify
them when accessing. To check the user-
name and password, press the [TOOLS]
button, select “Network”, and then check
the items “FTP Username” and “FTP
Password”.
Note:
When accessing by using Internet Explorer,
select “Open FTP Site in Windows
Explorer” on the Page tab after the connec-
tion.
6
Transfer the data.
In the same way as the normal file oper-
ation, move the file between the
CD/HDD receiver and the computer.
7
Close Windows Explorer.
8
Press [ENTER].
The message “Now Updating…”
appears and the CD/HDD receiver
updates the database in the HDD.
“Complete!” will be displayed and the
data transfer has been completed.
<ftp://xxx.xxx.xxx.xxx>
FTP Open/Close
:Open?
IP address
To Next Page
Loading...
