En-11
Before Using the CD Receiver
You can improve the sound quality by attaching the
included floor pads to raise the speakers off the surface
and reduce the contact area. The floor pads also make the
speakers stable and prevent them from slipping.
Remove the plastic film before using the remote
controller.
When using the remote controller, point it toward the CD
receiver’s remote control sensor, as shown below.
Use only a battery of the same type (CR2025).
Notes:
• If the remote controller doesn’t work reliably, try
replacing the batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as
possible to prevent damage from leakage or corrosion.
Caution:
• Replacing the battery incorrectly may cause an
explosion. Use only a battery of the same type or an
equivalent.
Using the Included Floor Pads for
speakers (CS-245DAB only)
Using the Remote Controller
Positive + side
Back side
Firmly insert a thin stick or similar
object into the hole, and pull out
firmly in the direction of the arrow.
To Next Page
Loading...
Need help?
General
